TU Darmstadt / ULB / TUbiblio

Browse by Person

Up a level
Export as [feed] Atom [feed] RSS 1.0 [feed] RSS 2.0
Group by: No Grouping | Item Type | Date | Language
Number of items: 8.

Schulz, Herbert and Stoic, A. and Sahm, A. (2001):
Improvement of cutting process in accordance with process disturbances.
In: CIM 2001: International Scientific Conference on Production Engineering <7, 2001, Lumbarda, Korcula>; Proceedings. - Zagreb: HVPS, 2001, Zagreb, HVPS, [Conference or Workshop Item]

Schulz, Herbert and Sahm, A. (2001):
Influence of heat treatment and cutting parameters on chip formation and cutting forces in high speed machining.
In: International Conference on High Speed Machining <3, 2001, Metz>: Proceedings. - Metz: École Nationale d'Ingenieurs, 2001, Metz, École Nationale d'Ingenieurs, [Conference or Workshop Item]

Blümke, Ralf and Sahm, A. and Müller, C. and Blümke, R. and Müller, C. (2001):
Influence of heat treatment on chip formation in high speed milling.
In: Scientific fundamentals of HSC, München, Hanser, pp. 43-52, [Book Section]

Reuter, Ulrich and Sahm, A. and Schulz, Herbert (2000):
CGI production on transfer lines and machining centres.
In: CGI Machining Workshop <2000>: Tagungsbd. - Darmstadt: Techn. Univ., PTW, 2000, Darmstadt, Techn. Univ., [Conference or Workshop Item]

Reuter, Ulrich and Sahm, A. and Schulz, Herbert and Heck, M. and Ortner, H. and Konetschny, C. (2000):
The wear process of CGI cutting and machining developments.
In: CGI Machining Workshop <2000>: Tagungsbd.- Darmstadt: Techn. Univ., PTW, 2000, Darmstadt, Techn. Univ., [Conference or Workshop Item]

Blümke, Ralf and Sahm, A. and Siems, S. and Müller, C. and Exner, H. E. and Schulz, Herbert and Warnecke, G. (2000):
Charakterisierung der Spanbildung bei Kurzzeitbelastung während des Hochgeschwindigkeitsfräsens.
In: Spanen metallischer Werkstoffe mit hohen Geschwindigkeiten, Bonn, Deutsche Forschungsgem., pp. 23-35, [Book Section]

Dörr, Joachim and Sahm, A. (1999):
Erfahrungen mit Minimalmengen-Schmierung.
132, In: Werkstatt und Betrieb, pp. 38-48, [Article]

Schulz, Herbert and Stanik, M. and Sahm, A. (1999):
Unterschiede direkter und indirekter Meßsysteme an Vorschubachsen von Werkzeugmaschinen.
89, In: wt Werkstattstechnik, pp. 315 ff., [Article]

This list was generated on Tue Dec 10 02:12:43 2019 CET.